FIGURES, CHARTS, AND TABLES IN THE ISD SERIES DATA SHEET . ISD Series Device Pin/Pad Designations, with Respect to Die Center (µm). ISDMP Datasheet, ISD SPI Interface Record and Playback IC Datasheet, buy ISDMP Voice Record IC. ISDMP datasheet, ISDMP circuit, ISDMP data sheet: WINBOND – Single-Chip Voice Record/Playback Devices 8-, , , and.
|Published (Last):||25 September 2017|
|PDF File Size:||11.56 Mb|
|ePub File Size:||16.48 Mb|
|Price:||Free* [*Free Regsitration Required]|
In addition, the device can be re- recorded typically overtimes. Playback and record operations are initiated when the device is enabled by asserting the SS pin LOW, shifting in an opcode and an address data to the ISD device refer to the Opcode Isd0404 in the following page. The duty cycle on the input clock is not critical, as the clock is immediately divided by two.
Memory Architecture The ISD series contains a total of 3,K Flash memory cells, which is organized as 2, rows of 1, cells each. Message Cueing can be selected only at the beginning of a playback operation.
ISDMP Datasheet(PDF) – Winbond
Functional operation is not implied at these conditions. Stresses above those listed may cause permanent damage to the device. Exposure to the absolute maximum ratings may affect device reliability and performance. The address bits A0-A15 are used to access various rows for multiple messages of different durations.
The CMOS-based devices include an on-chip oscillator, anti-aliasing filter, smoothing filter, AutoMute feature, audio amplifier, and high density multilevel Flash memory array.
Otherwise the ISD will repeat the operation from the same row address.
ISD4004 Series ChipCorder
Refer to the AC timing table for other T to different fatasheet rates. This is the serial output of the ISD device Copy your embed code and put on your site: In this mode, the messages are skipped 1, times faster than the normal playback mode.
Oct 31, – 4 – Revision 1. Oct 31, Revision 1. Elcodis is a trademark of Elcodis Company Ltd.
Oct 31, – 1 – Revision 1. If the XCLK is not used, this input must be connected to ground. Remove the leaded package option Remove the extended temperature option Update the external clock description Revise Ordering Information section 1.
Download datasheet Kb Share this page. All other trademarks are the property of their respective owners.
When a record command is sent, T  Measured with AutoMute feature disabled. Oct 31, Revision This is the serial input to the ISD device when it is configured as slave. Care should be taken such that the data shifted in is compatible with current system operation possible to read interrupt data datasheet start a new operation at the same time The ISD series is designed to be used in a microprocessor- or microcontroller-based system.
Oct 31, – 2 – Revision 1.
To minimize noises, the analog and digital circuits in the ISD devices use separate power busses. In addition, these supplies should be decoupled as close to the package as possible.