BV20 LATHE PDF

Cheap lathe used, Buy Quality lathe part directly from China lathe router Suppliers: mini lathe BV20 for sale Enjoy ✓Free Shipping Worldwide! ✓Limited Time. My 83yo Dad has asked me to sell his BV He bought it new many years ago. It has knurling tools etc and he may be able to find the manual. Idealy, your lathe should be installed close to a correctly rated BVBL. Motor. V a.c. W. Maximum swing over the bed. mm. Maximum distance.

Author: Kigasar Douk
Country: Spain
Language: English (Spanish)
Genre: Software
Published (Last): 18 June 2017
Pages: 206
PDF File Size: 10.31 Mb
ePub File Size: 12.17 Mb
ISBN: 486-8-38217-815-2
Downloads: 18903
Price: Free* [*Free Regsitration Required]
Uploader: Zushicage

I latye wanted a quick change toolpost for a long time, so at last I decided to splash out and get one. This is approximately a “9×20” size. Other people, such as Warco, do a similar lathe. Axminster originally listed a toolpost which they claimed was specifially for the BV20, but I spent over a month waiting for it to come in stock and it never did.

I suspect that it was the same design as the one shown below anyway.

There is a toolpost going around which fits the Myford 7 lathe. Several people stock it, but after a few phone calls RDG Tools proved to be the most helpful – the chap actually had one there and could tell me the dimensions of it. I ordered a 5-piece set main block, two plain holders, one boring bar holder, and one parting tool holder and it arrived next day, which impressed me hugely.

  6N137 AVAGO PDF

I thought I would put up some photos and dimensions of the toolpost, to give you an idea of whether it might be suitable for your own lathe. Excellent appearance – all surfaces are ground and it arrived neatly packed and well-coated in protective grease.

BV20 Lathe Quick Change Toolpost (24/08/11)

It doesn’t gv20 to be hardened, but I don’t think this is very significant. In fact, it may be a bonus, if I ever need to drill the main block for locating pins or whatever.

The locking screws on the main block were a little crunchy, but after removing them and the pistons press the piston in towards the main block and pull larhe locking screw up and out and giving things a clean, they work fine. Not a big deal – I made a quick tool with an old 8mm hex socket with a T-handle attached.

There were no problems about fitting it – the old toolpost came off, and the new one plonked straight on. The toolpost is fixed with an M10 bolt through the middle. For the odd big tool I can easily swap back to the original toolpost. Adjusting the height and changing tools is a breeze, and makes me wonder why I messed around with packing up tools for all these years.

  C4DES MAGAZINE PDF

I have ordered a set of five additional holders, because you really need a holder dedicated to each tool to make maximum use of a quick change toolpost. I have made a drawing of the toolpost dimensions, available as a PDF here. Please note, these dimensions are not exact, they are just to give you a rough idea of suitability.

Home News Links About.

BV20 Lathe Quick Change Toolpost

The rather wonky hex spanner. Very shallow hex socket. Removed – held by a single bolt. Three tool holders with tools.

The two pairs of screws allow short lengths of HSS bits to be held in both ends. Boring tool holder – note the V groove.